Your current location: Home-> Service and Support->Search result
Product search support
Product Support
Firmware Update-TX-NR5008 Firmware Update  Time:2018-12-23
User Manual Download-Time:2011-11-01
User Manual
Firmware Update
Software Update
News and Notice

TX-NR5008 Firmware Update             


Update History

Latest Firmware Number (16 digits):1101-0800-0310-2101

As of 10 Jul 2012

  • Stabilizes the operation of Network Control 

 As of 28 March 2012

  • Improves noise during playback of DTS-HD Master Audio with particular Blu-ray disc (Star Wars: The Complete Saga (Episodes I-VI) [Blu-ray])

As of 20 December 2011

  •  Stabilizes audio output when Zone 2 (or 3) is turned on before the main power 

           * This fix is only applied for Pre-Amp models 

As of 26 September 2011

  •  Adds support of Onkyo Remote App for Android. *it is also necessary to update the App. 

 As of 11 November 2010

  • Improves the playback of particular wav file;
  • Corrects intermittent activation of Auto Power Down function during playback in NET/USB mode;

As of 28 October 2010

  • Stabilizes the initializing process when [NET/USB] mode is activated on a busy network;
  • Improves the playback speed of certain VBR (Variable Bit Rate) MP3 files.

As of 22 September 2010

  • Improves Audyssey MultEQ XT32 processing (Note: after installing the update, you need to run the MultEQ XT32 speaker set-up again);
  • Enhances the operability and display of network/USB-related functions.

Precautions for TX-NR5008 Firmware Update

  1. Please read the update instructions carefully before beginning. 
  2. The firmware update should take 30 to 40 minutes. Once the update begins, don't turn off the power supply to the A/V receiver until it is time to restart it.
  3. Depending on the conditions of the network, a firmware update via a network may take more than one hour or even fail to finish. If the update is not completed within two hours, turn off the power supply by pushing the ON/STANDBY button and then try updating again from the beginning.
  4. Updating the firmware and adjusting the settings will be done automatically, but may take some time to complete. Please follow the procedures as instructed when you update. Note that the update may fail, or cause problems for your A/V receiver, if you do any of the following:
    • Pull out the A/V receiver’s power cord;
    • Interrupt the power supply to the A/V receiver (e.g. if the breaker is tripped or if there is an electrical outage);
    • Insert or remove the LAN cable from a device in your network when updating over a network; 
    • Insert or remove a USB memory device from the A/V receiver when updating via USB;
    • Operate components connected to the A/V receiver via HDMI, such as a TV or a recording device.

     If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will repair the unit for a fee. 

    For detail about Open Source Software, please refer to the link below.



    Site Map  |   Contact Us  |   Join Us  |   Terms & Conditions  |   Privacy Policy  |   Delivery and Return Policy  |   Links  

    © 2015 Pioneer & Onkyo Marketing Asia Ltd. All rights reserved.