v
Your current location: Home-> Service and Support->Search result
Product search support
v
TX-NR709
Product Support
Firmware Update-TX-NR709 Firmware Update  Time:2018-12-23
User Manual Download-Time:2011-12-19
User Manual
Firmware Update
Software Update
FAQ
News and Notice

TX-NR709 Firmware Update             

  

      

Latest Firmware Number (12 digits): 1131-1377-0211-4107

As of 13 June 2013

Information Concerning Firmware Update for Onkyo Network Receivers

Onkyo has discovered there is a possibility of failure when updating receivers to this new firmware package via ethernet in certain network environments.

For this reason, we are now only releasing a firmware file for installation via USB port / flash memory device.

Users should first check to see if their network receiver is running the latest firmware (1100-7101-0100-0000 released July 24, 2012) before installing this update via USB.If your network receiver is not running firmware version 1100-7101-0100-0000, please update your receiver to this version via the network facility before proceeding further.

To check your firmware version, press the "Home" button on your remote control. Highlight "F/W Update" or select the "Firmware Update" icon and press enter.

Your current firmware version will be displayed on the front panel of your A/V receiver as well as your TV screen.

Should you encounter any difficulties when performing this update, please contact us.

We appreciate your understanding and apologize for any inconvenience this issue may cause.


  •  Corrects the problem that the OSD menu does not appear when certain source components connected via HDMI are in standby mode;

 

Precautions for TX-NR709 Firmware Update

  1. Please read the update instructions carefully before beginning.
  2. The firmware update should take 30 to 40 minutes. Once the update begins, don't turn off the power supply to the A/V receiver until it is time to restart it.
  3. Depending on the conditions of the network, a firmware update via a network may take more than one hour or even fail to finish. If the update is not completed within two hours, turn off the power supply by pushing the ON/STANDBY button and then try updating again from the beginning.
  4. Updating the firmware and adjusting the settings will be done automatically, but may take some time to complete. Please follow the procedures as instructed when you update. Note that the update may fail, or cause problems for your A/V receiver, if you do any of the following:
    • Pull out the A/V receiver's power cord;
    • Interrupt the power supply to the A/V receiver (e.g. if the breaker is tripped or if there is an electrical outage);
    • Insert or remove the LAN cable from a device in your network when updating over a network;
    • Insert or remove a USB memory device from the A/V receiver when updating via USB;
    • Operate components connected to the A/V receiver via HDMI, such as a TV or a recording device.

     If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will repair the unit for a fee.

    For detail about Open Source Software, please refer to the link below.

    https://www.onkyo.com/manual/oss/rcv01.pdf 

     

    Site Map  |   Contact Us  |   Join Us  |   Terms & Conditions  |   Privacy Policy  |   Delivery and Return Policy  |   Links  
    |  

    © 2015 Pioneer & Onkyo Marketing Asia Ltd. All rights reserved.
    rss
    v